Hull-less barley flour supplemented corn extrudates produced by conventional extrusion and CO2 injection process


Tugrul Masatcioglu M. T., Yalcin E., Hwan P. J., Ryu G., Celik S., Koksel H.

Innovative Food Science and Emerging Technologies, cilt.26, ss.302-309, 2014 (SCI-Expanded) identifier identifier

  • Yayın Türü: Makale / Tam Makale
  • Cilt numarası: 26
  • Basım Tarihi: 2014
  • Doi Numarası: 10.1016/j.ifset.2014.06.003
  • Dergi Adı: Innovative Food Science and Emerging Technologies
  • Derginin Tarandığı İndeksler: Science Citation Index Expanded (SCI-EXPANDED), Scopus
  • Sayfa Sayıları: ss.302-309
  • Anahtar Kelimeler: Corn flour, Extrusion with CO2 injection, Hull-less barley, Pasting properties, Resistant starch, β-Glucan
  • Hatay Mustafa Kemal Üniversitesi Adresli: Evet

Özet

The effects of feed moisture content (20, 25%), exit-die temperature (80, 130 °C), and extrusion-cooking method (with/without CO2 injection) on β-glucan (BG) levels and physicochemical properties of hull-less barley flour (HBF) supplemented (15, 30, 45%) corn extrudates were investigated. The highest HBF supplementation level (45%) resulted in higher BG levels (2.87-3.28%) in all extrusion conditions. In general, increasing feed moisture content from 20 to 25% and exit-die temperature from 80 to 130 °C resulted in small increases in enzyme resistant starch type-3 (RS3) levels. However, the investigated extrusion conditions did not form substantial amount of RS3 and the highest RS3 content was 540 mg/100 g. Lower feed moisture content and higher exit-die temperature resulted in higher water solubility (WS) and lower water-binding capacity (WBC) values. Cold-paste viscosity (CV) was observed in all extrudates. High WS and WBC values of extrudates and the existence of CV values in RVA curves indicated complete starch gelatinization. Industrial relevance CO2 injection has been proved as a reliable alternative method to the conventional extrusion process used in the breakfast cereals and snack food industry. The overall quality of the product processed by CO2 injection was comparable to that of the current process. The extrudates produced by CO2 injection method had more uniform expansion and smoother surface. CO2 injection did not have a reducing effect on β-glucan levels; however, it is expected to result in a better retention of heat labile micronutrients and hence more healthy food products.